# $Id: cirrus,v 1.1.1.1 2005/11/11 21:32:01 faxguy Exp $
#
# HylaFAX Facsimile Software
#
# Copyright (c) 1990-1996 Sam Leffler
# Copyright (c) 1991-1996 Silicon Graphics, Inc.
# HylaFAX is a trademark of Silicon Graphics, Inc.
# 
# Permission to use, copy, modify, distribute, and sell this software and 
# its documentation for any purpose is hereby granted without fee, provided
# that (i) the above copyright notices and this permission notice appear in
# all copies of the software and related documentation, and (ii) the names of
# Sam Leffler and Silicon Graphics may not be used in any advertising or
# publicity relating to the software without the specific, prior written
# permission of Sam Leffler and Silicon Graphics.
# 
# THE SOFTWARE IS PROVIDED "AS-IS" AND WITHOUT WARRANTY OF ANY KIND, 
# EXPRESS, IMPLIED OR OTHERWISE, INCLUDING WITHOUT LIMITATION, ANY 
# WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.  
# 
# IN NO EVENT SHALL SAM LEFFLER OR SILICON GRAPHICS BE LIABLE FOR
# ANY SPECIAL, INCIDENTAL, INDIRECT OR CONSEQUENTIAL DAMAGES OF ANY KIND,
# OR ANY DAMAGES WHATSOEVER RESULTING FROM LOSS OF USE, DATA OR PROFITS,
# WHETHER OR NOT ADVISED OF THE POSSIBILITY OF DAMAGE, AND ON ANY THEORY OF 
# LIABILITY, ARISING OUT OF OR IN CONNECTION WITH THE USE OR PERFORMANCE 
# OF THIS SOFTWARE.
#

#
# Configuration for modems based on the Cirrus Logic Chipset
# (such as the builtin modem that comes with a WinBook XP).
#
# This configuration file sets up the modem for
# 57.6 w/ hardware flow control.
# 
# CONFIG:CLASS1:1.02:.*:.*: Manufacturer="Cirrus Logic" Model="CL-MD1414AT/EC"
# CONFIG:CLASS1:1.0:CL-MD34*:.*: Manufacturer="Cirrus Logic" Model="CL-MD34xx"
# CONFIG:CLASS1:1.0:CL-MD56*:.*: Manufacturer="Cirrus Logic" Model="CL-MD56xx"
# CONFIG:CLASS1:.*:MD56xx:.*: Manufacturer="Intel/Ambient/Cirrus Logic" Model="CL-MD56xx"
#
# BEGIN-SERVER
# END-SERVER
#
# Modem-related stuff: should reflect modem command interface
# and hardware connection/cabling (e.g. flow control).
#
ModemType:		Class1		# use this to supply a hint
ModemRate:		57600		# rate for DCE-DTE communication
ModemFlowControl:	rtscts		# RTS/CTS flow control assumed
#
ModemSoftFlowCmd:	AT\Q1		# set desired flow control method
ModemHardFlowCmd:	AT\Q3		# set desired flow control method
ModemSetupDTRCmd:	AT&D3		# setup so DTR drop resets modem
ModemSetupDCDCmd:	AT&C1		# setup so DCD follows carrier
ModemDialCmd:		ATDT%s
#
# Happy days!  This modem has proper support for querying
# the model, manufacturer, and firmware revision!
#
ModemMfrQueryCmd:	AT+FMFR?
ModemModelQueryCmd:	AT+FMDL?
ModemRevQueryCmd:	AT+FREV?

Class1PPMWaitCmd: 	"<delay\0727>"	# \072 == :  to avoid awk problem
Class1TCFWaitCmd: 	"<delay\0727>"
Class1EOPWaitCmd: 	"<delay\0729>"
Class1SwitchingCmd:	"<delay\0727>"	# assumption: +FRS not supported