# $Id: moto-288,v 1.1.1.1 2005/11/11 21:32:01 faxguy Exp $
#
# HylaFAX Facsimile Software
#
# Copyright (c) 1990-1996 Sam Leffler
# Copyright (c) 1991-1996 Silicon Graphics, Inc.
# HylaFAX is a trademark of Silicon Graphics, Inc.
# 
# Permission to use, copy, modify, distribute, and sell this software and 
# its documentation for any purpose is hereby granted without fee, provided
# that (i) the above copyright notices and this permission notice appear in
# all copies of the software and related documentation, and (ii) the names of
# Sam Leffler and Silicon Graphics may not be used in any advertising or
# publicity relating to the software without the specific, prior written
# permission of Sam Leffler and Silicon Graphics.
# 
# THE SOFTWARE IS PROVIDED "AS-IS" AND WITHOUT WARRANTY OF ANY KIND, 
# EXPRESS, IMPLIED OR OTHERWISE, INCLUDING WITHOUT LIMITATION, ANY 
# WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.  
# 
# IN NO EVENT SHALL SAM LEFFLER OR SILICON GRAPHICS BE LIABLE FOR
# ANY SPECIAL, INCIDENTAL, INDIRECT OR CONSEQUENTIAL DAMAGES OF ANY KIND,
# OR ANY DAMAGES WHATSOEVER RESULTING FROM LOSS OF USE, DATA OR PROFITS,
# WHETHER OR NOT ADVISED OF THE POSSIBILITY OF DAMAGE, AND ON ANY THEORY OF 
# LIABILITY, ARISING OUT OF OR IN CONNECTION WITH THE USE OR PERFORMANCE 
# OF THIS SOFTWARE.
#

#
# Configuration for a Motorola RC288DPi-based Class 1 modem.
#    Lifestyle 28.8		S209415900 -01 1/16/95    3:30 PM
#
# CONFIG:CLASS1:288:Motorola:.*: Manufacturer=Motorola Model=28.8
#
# BEGIN-SERVER
# END-SERVER
#
# Modem-related stuff: should reflect modem command interface
# and hardware connection/cabling (e.g. flow control).
#
ModemType:		Class1		# use class 1 interface
ModemRate:		19200		# locked for fax sending&receiving
ModemFlowControl:	rtscts		# default
#
ModemNoFlowCmd:		AT\Q		# disable flow control cmd
ModemSoftFlowCmd:	AT&R1\Q1	# software flow control cmd
ModemHardFlowCmd:	AT&R\Q3		# hardware flow control cmd
ModemSetupDTRCmd:	AT&D3		# DTR off causes modem to reset
ModemSetupDCDCmd:	AT&C1		# DCD follows carrier
ModemSetupAACmd:	AT+FAA=1
#
ModemAnswerCmd:		"AT*FR\nATA"	# enable autobaud before answering
ModemWaitForConnect:	yes		# modem sends FAX/DATA first
#
# Apparently Rev 2 of the firmware requires that you send ATO
# to initiate a data connection when adaptive answer is set; the
# following will send ATO and then wait for the CONNECT response.
#
ModemAnswerDataBeginCmd:"ATO\n<waitfor\072CONNECT>"
#
ModemMfrQueryCmd:	!Motorola
ModemModelQueryCmd:	!28.8
ModemRevQueryCmd:	AT%V		# model and firmware rev
#
ModemDialCmd:		ATDT%s		# T for tone dialing
#
# Caller ID configuration setup; add AT*ID1 to ModemResetCmds
# to enable functionality (when supported by the local Telco).
#
#CallIDPattern:		"CALLER NUMBER: " # pattern string for phone number info
#CallIDPattern:		"CALLER NAME: "	# pattern string for identity info
#